XC Robotics | HMI alarm

OTC DAIHEN Teach Pendant Communication Alarm Guide

Teach pendant communication alarms usually mean the robot controller cannot maintain a clean link to the handheld HMI, cable, or related interface hardware.

This symptom guide helps prepare a support request; it is not a controller-specific alarm-code reference. Record the exact displayed code and consult the manual for the installed controller and software version.

Typical symptoms

The pendant disconnects intermittently, freezes, or does not initialize properly.

Operators may report missing display response, unstable keys, or communication alarms during startup.

The issue may worsen when the pendant cable is bent, moved, or reconnected.

Likely causes

Damaged pendant cable, connector wear, or strain near the handheld entry point

Incorrect or aging pendant generation paired with the controller environment

Controller-side interface or PCB issues affecting communication stability

First checks before requesting a replacement

Before physical inspection, a qualified technician must follow the equipment manual and site isolation procedure. Do not reconnect components while energized or bypass safeguards.

Photograph the pendant front, back label, connector side, and controller label together.

Check whether the failure changes when the cable is repositioned or the connector is reseated.

Separate a physical display problem from a communication alarm by noting boot behavior and key response.

What to send for faster matching

Pendant photos, controller photos, and any visible connector damage

Whether the pendant powers on, freezes, or stays blank from startup

Any prior replacement history or evidence that the cabinet-side board is also suspect

Teach pendant communication FAQ

Is the pendant itself always the failed part?

No. Communication alarms can also come from the pendant cable, connector wear, or controller-side interface boards.

What gives the fastest compatibility check?

Clear photos of the pendant label, connector, and controller label are usually the fastest way to narrow the correct replacement path.

Back to alarm library