XC Robotics | Parts IdentificationPublished: Apr 18, 2026

How to Identify the Correct OTC DAIHEN Teach Pendant Model

A practical guide for buyers and maintenance teams who need to match an OTC DAIHEN teach pendant by controller generation, connector, and label details.

Why teach pendant matching often fails

Many inquiries only include a front photo of the pendant. That is rarely enough because OTC DAIHEN pendants can differ by controller generation, cable connector, and software family.

If the wrong unit is quoted, the result is usually a delay in maintenance or a pendant that cannot be used directly on site.

What information you should collect first

Start with the controller model or controller generation. That is usually the fastest way to narrow the compatible pendant family.

Then collect close photos of the pendant label, connector side, cable end, and any visible serial or part number. These details are more useful than a screen photo alone.

What to send when requesting a quote

Send the robot model, controller model, pendant label photo, connector photo, and a short note describing whether the issue is screen damage, cable damage, or intermittent communication.

With that information, a supplier can usually confirm whether you need a full teach pendant, a pendant cable, or a controller-side accessory.

Prepare useful identification photos

Take one overview showing where the component is installed, one readable nameplate image, and close-ups of connectors and part markings. Keep model suffixes and revision letters visible.

Include the exact symptom, when it began and any recent changes. Photos help identification but do not establish the cause of a fault.

Teach Pendant FAQ

Can I match a teach pendant with only the robot model?

Sometimes, but controller generation is usually more important. The same robot family may have been paired with different controllers over time.

Should I replace the full unit or only the cable?

That depends on the failure point. If the screen and buttons still work, a cable-only replacement may be possible, but label and connector photos are needed first.