XC Robotics | Feed alarm

OTC DAIHEN Wire Feed Instability Alarm Guide

Wire-feed instability alarms usually appear when the feeder cannot deliver wire smoothly enough for the programmed weld schedule and arc behavior.

This symptom guide helps prepare a support request; it is not a controller-specific alarm-code reference. Record the exact displayed code and consult the manual for the installed controller and software version.

Typical symptoms

Wire does not feed consistently, slips, or stops during arc start and restart.

Operators may see birdnesting, inconsistent arc length, or rapid contact-tip wear.

The issue may worsen with specific wire diameters, liner bends, or spool conditions.

Likely causes

Drive-roll wear, feeder tension mismatch, or dirty feeder path

Liner drag, contact-tip restriction, or torch cable routing that creates excess resistance

Process settings that do not match the actual wire, material, or feeder generation

First checks before replacing components

Before physical inspection, a qualified technician must follow the equipment manual and site isolation procedure. Do not reconnect components while energized or bypass safeguards.

Confirm wire diameter, material, feeder label, and Welbee power-source model.

Inspect drive rolls, liner condition, contact tips, and spool drag before changing electrical parts.

Record whether the failure happens during arc start, continuous welding, or restart after short pauses.

What to send when asking for support

A short video of the feed problem together with photos of the feeder label and torch consumables

Wire size, wire material, and the power-source model running the program

Whether the issue started after replacing a liner, feeder, or welding schedule

Wire feed FAQ

Does inconsistent wire feed always mean the feeder must be replaced?

No. The root cause is often in liner drag, drive-roll wear, contact-tip restriction, or a mismatch between the actual wire setup and the welding program.

What parts are most often screened first?

Teams usually screen drive rolls, liner, feeder components, contact tips, and the torch cable route before moving to deeper electrical checks.

Back to alarm library